Why does door ajar light stay on

Additional Services. Nationwide Warranty. About Us. Meet Our Staff. Vehicles We Service. View Map. Emissions Stations.

With the new wires in place, opening the door closing the switch sends an electrical current to the brain in addition to the inside lights. When this current flows, it causes the brain to sound the alarm. Removing Wireless ADT Window and Door Sensors You can usually slide through the adhesive and completely remove the sensor with a putty knife at this point.

You can also use a blow dryer or hot air gun to sufficiently heat the silicone, softening it for easier cleanup and sensor removal. You can remove a wired recessed sensor by pulling it out from the frame of the door or window.

Then do the same with its magnet…. Over time there is no amount of door slamming that can get that always-on, retina-burning, constant-reminder-of-your-decision-to-buy-a-Ford to shut off. Edge owners have been complaining about it in record numbers, often recording three spots on the Trending Complaints list on CarComplaints. That means owners can expect to pay for repairs. While a warning light is annoying, the "door ajar" issue is much deeper that. I will sue Ford for not having a reasonable recall.

This is the biggest issue with the Ford Edge. However, one Edge owner said she was told by Ford the vehicles hadn't been recalled because there hadn't been enough complaints. EDIT: These images show what most of the door sensors look like on newer cars, they can either be on the car body where the door will press against it when closed or on the door where it will be pressed against the car body when the door is closed.

They are in different places on every car, essentially they are like a little button that you can push in with your finger, on most new cars they are covered with a bit of rubber so they are not as visible.

My toyota hilux has these sensors. The problem is that if the car is turned off, the sensor will not detect that the door is already closed, hence I cannot lock it. But if the car is on, the sensor works just fine. What could be wrong? Jamie Nye fidd. My Mazda Tribute just had the same problem, it has internal sensors in the door latch. One door handle felt a bit loose, it would open the door and the lock would hold when the door closed but the handle still felt loose, so I checked this one first.

On removing the inner door panel I could see a part not fully returning, so sprayed some WD40 on this and wriggled it till it it returned fully every time, taking the looseness out of the handle and fixing the light problem. Light is always on even though all doors are properly shut off. It started when i removed the bonnet and tried on a new one. What possibly causes this? My Rogue had front driver door open, door locks were locking and unlocking.

Took vehicle to Nissan dealership, they looked at driver door and noticed dents on door frame where the door contacts the activator switch, dents were caused by closing door on seatbelt, we filled dented area in with tape and it corrected the problem immediately…. Hope it helps …. Fix Your Stuff Community Store.